Ability to still use program whilst cutting design

alliellis · Post by **alliellis** » Fri Jul 09, 2010 10:23 am

I was cutting a word book the other day and wanted to make an adjustment to Page 2 but the program makes you wait until the current page has finished cutting. Wouldn't it be good if whilst your machine is cutting one design, you could be working on your next, instead of sitting there waiting?

jayem · Post by **jayem** » Sat Jul 10, 2010 12:05 am

Allie, I totally agree.

I haven't tried it but I wonder if you could have two copies of SCAL open and alternate between them in cutting. I will give it a go later this evening and let you know.

HeatherM · Post by **HeatherM** » Sat Jul 10, 2010 4:45 am

You can have two copies open at once. HTH

judyjo · Post by **judyjo** » Sat Jul 10, 2010 5:17 am

Is it possible to have two copies open at same time on a Mac?

alliellis · Post by **alliellis** » Sat Jul 10, 2010 10:30 am

Thanks everybody. I will try it out

Maggie · Post by **Maggie** » Tue Oct 19, 2010 8:05 am

I'd like that feature as well! YES!

Craft Edge

Ability to still use program whilst cutting design

Ability to still use program whilst cutting design

Re: Ability to still use program whilst cutting design

Re: Ability to still use program whilst cutting design

Re: Ability to still use program whilst cutting design

Re: Ability to still use program whilst cutting design

Re: Ability to still use program whilst cutting design