Cutting Lines across design
-
DevilEleven11
- Posts: 1
- Joined: Thu Dec 27, 2018 12:26 pm
Cutting Lines across design
Just purchased a used zing air from a friend. Have done all the calibration & setup stuff correctly i believe. Problem is I am getting a line across the design after it runs the design it comes back across and presses down for a line? Any suggestions?? All help would be appreciated. Thanks,
- Attachments
-
- IMG_1741.jpg (125.72 KiB) Viewed 1426 times
Re: Cutting Lines across design
Did you purchase a registration number for SCAL and register it? That appears to be the "watermark" added when SCAL is in trial mode.
Sandy McCauley
Owner of http://www.iloveknk.com/
Owner of http://www.iloveknk.com/